close
close

How To Light Pilot Light On Valor Gas Fireplace References

0 Comments

How To Light Pilot Light On Valor Gas Fireplace References. Next, light your lighter and put its flame near the pilot light inside the fireplace or furnace, or press the clicker button to make sure that it is sparking (this may be hard to see in some fireplaces).now press the knob, or a button near the knob, to get gas flowing to the pilot light.often, this will involve manually depressing the pilot valve and using an electric ignitor or. How do you light the pilot on a valor fireplace?

Parts/Resources My Gas Fireplace Repair from www.mygasfireplacerepair.com

Push the igniter button once every second until it lights. The pilot knob should have the options “off,” “pilot” and, in some models, “on.”. Pilot light is off, gas is on, and when i turn it on with the wall switch.

A Standing Pilot Is Always On, Always Using A Small Amount Of Gas To Run Constantly Unless The Gas Is Physically Turned Off.

If the pilot light goes out, repeat steps 5 & 6. Press the control knob down and hit the ignition switch. Light a match or butane candle lighter and hold it near the burner in the fireplace.

Push The Button In While You Push The Starter.

If the pilot does not light, wait 5 minutes and try again. Valor gas fireplace will provide a warm, cozy, and of course, glowing light effect on the frigid day of winter. Pilot lights do not leak carbon monoxide when they go out.

Do You Know The Model Of Your Valor Fireplace?

Our own gas fireplace insert is an older model and the pilot light is the standing flame type rather than the intermittent pilot ignition found often found. The pilot knob should have the options “off,” “pilot” and, in some models, “on.”. A pilot light is a small flame that is kept alight using a steady, small stream of gas.

How Do You Light The Pilot On A Valor Fireplace?

Tap the switch until the pilot light ignites. Remember to shut the gas supply valve off (picture #1). Here’s how to light a gas fireplace with a control panel.

Using The Valor Wall Switch Press The Down Button.

Turn the gas key to release gas to the burner. My pilot light will not stay lit gas fireplace gas. Keep trying periodically to light the pilot light.


Leave a Reply

Your email address will not be published.