close
close

How To Reset Oil Change On Jeep Grand Cherokee

0 Comments

How To Reset Oil Change On Jeep Grand Cherokee. Put your jeep in “park” and turn off the engine. An oil change is one of the most key and dominant services for your car.

How To Reset Oil Change Light on Jeep Grand Cherokee YouTube from www.youtube.com

Does anyone know how to reset the oil change due indicator? After these steps have been performed, you have successfully reset the oil life on the jeep cherokee if you are unable to reset the “oil change required” light utilizing one of these methods, repeat the steps. Be sure to go through your car owner’s manual to be sure of what the light looks like on the dashboard.

An Oil Change Is One Of The Most Key And Dominant Services For Your Car.

Turn ignition to run position, don’t start the engine. Start the engine normally after the ignition has been turned off, and the light should be reset after that. Put the transmission in park position and key in on position.

Use The Navigation Button In Order To Select Vehicle Info.

All information is taken from the jeep. If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. Fully depress the accelerator pedal slowly three times within 10 seconds.

Watch The Oil Change Or Maintenance Light Carefully.

Turn off the ignition and start the engine to make sure it worked. The fastest way to reset oil life and is usually used for all jeep models is by step on the gas pedal three times slowly within 10 seconds after turn the ignition to the run position. Turn the ignition back to the on position while holding the reset button.

Then Press & Hold The Reset Button Until The Mileage Resets.

Does anyone know how to reset the oil change due indicator? To reset the oil change indicator system (after performing the scheduled maintenance) refer to the following procedure. This also works for other mopar vehicles as w.

Press The Start/Stop Button To Turn The Electronics Off.

Scroll right to reach the oil life screen. Now you are going to hold down the ok button until you see that the oil life display has changed to 100 percent. Set the gear to the park position.


Leave a Reply

Your email address will not be published.